Differences

This shows you the differences between two versions of the page.

--- zwave_devices:eurotronic [2013/09/15 18:40] – mattb
+++ zwave_devices:eurotronic [2026/04/07 18:27] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
+===== Stella-Z =====
+Based on user feedback, it sounds like it can be difficult to make the Stella-Z stay awake during the Define/Sync process but it should eventually complete if you continue to wake the module.
+You will likely want to change the wake interval in the ''**Device Settings**'' sub-dialog. According to the Stella-Z manual it defaults to 7 days, which is impractical if you want to be able to remotely change the temperature setpoint or mode. We recommend trying a wake interval of every 4 (lowest allowed according to the manual) to 16 minutes. This will then be the interval or maximum delay for remotely changing setpoints / mode and receiving temperature updates. Note that removing the battery from the module appears to reset the wake interval back to 7 days, so be sure and reset to a more practical value after battery changes.
+Indigo maps the following thermostat modes to what the Stella-Z supports:
+  * Off -> Frost Protection Mode (there is no real "off" mode for the Stella-Z)
+  * Heat -> Comfort Mode
+  * Cool -> Undefined (don't use)
+  * Auto -> Undefined (don't use)
+There is no way currently to use Indigo to put it into the Energy Saving or Direct Control Modes. Energy Saving mode can be simulated by changing the setpoint values.
+Based on feedback it sounds like the Stella-Z doesn't report very accurate battery levels.
+[[http://www.indigodomo.com/devices/203/|Device details]]
+[[https://forums.indigodomo.com/viewtopic.php?f=53&t=10732|Discuss this device]]